Oracle Communications Session Border Controller — Question 15

What should you do to enable physical interface redundancy?

Answer options

• A. Navigate to the system-config configuration element and set the phy-redundancy parameter to enabled.
• B. Navigate to the network-interface configuration element and set the phy-redundancy parameter to enabled.
• C. Navigate to the network-interface configuration element and set the link-redundancy-state parameter to enabled.
• D. Navigate to the system-config configuration element and set the link-redundancy-state parameter to enabled.
• E. Run the superuser command enable phy-redundancy.

Correct answer: C

Explanation

The correct answer is C because enabling the link-redundancy-state parameter in the network-interface configuration is the specific action needed for physical interface redundancy. Options A and D incorrectly refer to the system-config instead of the network-interface. Option B incorrectly mentions the phy-redundancy parameter, which is not related to physical interface redundancy, while option E suggests using a command that is not applicable in this context.