LPIC-2 Exam 201 (Linux Engineer) Free Practice Exam Questions

48 real LPIC-2 Exam 201 (Linux Engineer) exam questions with answers and AI explanations. LPI certification prep — page 1 of 5.

1. Question 1: A Linux server running systemd booted to rescue.target for maintenance. Which commands are used to restore the server to its usual target? (Choose two.)
2. Question 2: Which of the following commands displays the physical path of the kernel module named dummy?
3. Question 3: Which of the following is a userspace application used to modify EFI entries on a Linux system?
4. Question 4: Which of the following commands adds a static IPv6 address to the network interface eth0?
5. Question 5: After the downloading patch-4.6.4.xz from http://kernel.org, what are the next steps to prepare the build of a version 4.6.4 Linux kernel? (Choose two.)
6. Question 6: On a server running the 3.4.50-11 Linux kernel, which file in the /boot directory contains the kernel configuration parameters?
7. Question 7: Which of the following commands shows capabilities and usable frequencies for the wireless interface wlan0?
8. Question 8: What is the minimum number of disks required in a fully redundant RAID5 array?
9. Question 9: The following command has just been run successfully: Cd /opt; tar xvf /dev/nst0; What will happen if the command sequence is run again?
10. Question 10: Which of the following commands erases the contents of the /dev/sdb3 partition?