Citrix ADC 13 Administrator — Question 25

Scenario: A Citrix Administrator has configured the following Access Control List (ACL) to block traffic from the IP address 10.102.29.5. add simpleacl rule1 DENY srcIP 10.102.29.5
A week later, the administrator found that the ACL is no longer present on the NetScaler.
What could be the reason for this?

Answer options

• A. The administrator did NOT run the apply ACL command.
• B. The NetScaler has been restarted without saving the configurations.
• C. The Simple ACLs remain active for only 600 seconds.
• D. The Simple ACLs remain active for only 60 seconds.

Correct answer: A

Explanation

The correct answer is A because if the apply ACL command is not run, the ACL changes will not take effect and will not be saved. Option B is incorrect as a reboot alone wouldn't remove unsaved configurations unless they were not applied. Options C and D are wrong because Simple ACLs can remain active beyond the stated time frames, depending on the configuration.