Implementing Cisco Advanced Call Control and Mobility Services (CLACCM) — Question 102

An engineer is troubleshooting an intersite call between two endpoints where the call fails and the message “Not Enough Bandwidth” is displayed. G.729 codec is in use on both sites. First, calls are being properly routed, and the issue happens after the third call is established and the bandwidth utilization between the two sites is under 50%. Which configuration in Cisco UCM must be adjusted to resolve the issue?

Answer options

• A. transcoder
• B. location
• C. route pattern
• D. translation pattern

Correct answer: B

Explanation

The correct answer is B because the location configuration in Cisco UCM controls bandwidth allocation between sites, and it needs to be adjusted to allow more calls to be established without running into bandwidth limitations. The other options, such as transcoder, route pattern, and translation pattern, do not directly address the bandwidth management aspect that is causing the issue.