Implementing Cisco Enterprise Wireless Networks (ENWLSI) — Question 265

An engineer must configure Cisco OEAPs for three executives. As soon as the NAT address is configured on the management interface, it is noticed that the WLC is not responding for APs that are trying to associate to the internal IP management address. Which command should be used to reconcile this?

Answer options

• A. config flexconnect office-extend nat-ip-only disable
• B. config network ap-discovery nap-ip-only enable
• C. config flexconnect office-extend nat-ip-only enable
• D. config network ap-discovery nat-ip-only disable

Correct answer: D

Explanation

The correct command, 'config network ap-discovery nat-ip-only disable', disables the NAT IP-only mode for AP discovery, allowing the WLC to respond to APs using the internal management address. The other options either enable NAT IP-only mode or are incorrectly configured, which would not resolve the issue of the WLC not responding.