Designing Cisco Enterprise Wireless Networks (ENWLSD) — Question 105

An engineer must produce a passive survey report. The coverage heat map shows the entire site with all signal levels. To see only the desired coverage, which action must the engineer take?

Answer options

• A. Change the color scheme to show the desired heat map.
• B. Use the RSSI calibration tool to configure the receiver sensitivity.
• C. Use the RSSI slider to set the heat map to the desired cutoff filter.
• D. Filter the results to show the desired APs only.

Correct answer: C

Explanation

The correct answer is C because using the RSSI slider allows the engineer to specify a cutoff filter, which directly affects the visibility of the desired coverage on the heat map. Options A and B do not provide the functionality needed to focus on specific coverage levels, while option D would limit visibility to certain access points rather than adjusting the overall coverage display.