Check Point Certified Security Expert (CCSE) R80 — Question 1

You noticed that CPU cores on the Security Gateway are usually 100% utilized and many packets were dropped. You don't have a budget to perform a hardware upgrade at this time. To optimize drops you decide to use Priority Queues and fully enable Dynamic Dispatcher. How can you enable them?

Answer options

• A. fw ctl multik dynamic_dispatching on
• B. fw ctl multik dynamic_dispatching set_mode 9
• C. fw ctl multik set_mode 9
• D. fw ctl multik pq enable

Correct answer: A

Explanation

The command 'fw ctl multik dynamic_dispatching on' directly enables the Dynamic Dispatcher, which is essential for optimizing CPU utilization. The other options either set modes or enable Priority Queues but do not activate the Dynamic Dispatcher, which is necessary for addressing the high CPU load and packet drops.