Check Point Certified Security Expert (CCSE) R81.20 — Question 104

To fully enable Dynamic Dispatcher on a Security Gateway:

Answer options

• A. Using cpconfig, update the Dynamic Dispatcher value to “full” under the CoreXL menu
• B. Edit /proc/interrupts to include multik set_mode 1 at the bottom of the file, save, and reboot
• C. run fw ctl multik set_mode 1 in Expert mode and then reboot
• D. run “fw ctl muitik dynamic_dispatching on” and then reboot

Correct answer: D

Explanation

The correct answer is D because it directly enables Dynamic Dispatcher through the command line, followed by a reboot. Options A, B, and C do not specifically activate Dynamic Dispatcher or contain inaccuracies in their commands, making them incorrect for this requirement.