Check Point Certified Security Administrator (CCSA) R80 — Question 216

While in SmartView Tracker, Brady has noticed some very odd network traffic that he thinks could be an intrusion. He decides to block the traffic for 60 minutes, but cannot remember all the steps. What is the correct order of steps needed to set up the block?
1) Select Active Mode tab in SmartView Tracker.
2) Select Tools > Block Intruder.
3) Select Log Viewing tab in SmartView Tracker.
4) Set Blocking Timeout value to 60 minutes.
5) Highlight connection that should be blocked.

Answer options

• A. 1, 2, 5, 4
• B. 3, 2, 5, 4
• C. 1, 5, 2, 4
• D. 3, 5, 2, 4

Correct answer: C

Explanation

The correct answer is C because it correctly follows the necessary steps: starting with selecting the Active Mode tab, highlighting the connection to be blocked, then choosing Tools > Block Intruder, and finally setting the Blocking Timeout to 60 minutes. The other options either begin with the Log Viewing tab or do not highlight the connection before blocking, which is essential.